Accelerator Pedal Concern Q&A – As Announced on January 21, 2010 and as published by Toyota Customer Services.

Q1: What is the condition?
A1: There is a possibility that certain accelerator pedal mechanisms may, in rare instances, mechanically stick in a partially depressed position or return slowly to the idle position.

Q2: What is the cause?
A2: Over time, some accelerator pedal mechanisms may become worn. As a result of this wear combined with certain operating and environmental conditions, friction in the mechanism may increase and intermittently result in the accelerator pedal being hard to depress, slow to return or, in the worst case, stick in a partially open position.

Q3: Are there any warnings that this condition exists?
A3: Gradually over a period of time, the driver may notice that the accelerator pedal is harder to depress or is slow to return. In some cases, the driver may notice a rough or chattered feeling when depressing/releasing the accelerator pedal.

Q4: Which and how many vehicles are involved?
A4: There are approximately 2.3 million vehicles involved.

• 2009 – 2010 Corolla
• 2009 – 2010 Matrix
• 2007 – 2010 Camry
• 2005 – 2010 Avalon
• 2009 – 2010 RAV4
• 2010 Highlander
• 2007 – 2010 Tundra
• 2008 – 2010 Sequoia

Q5: Are there any other Toyota or Lexus vehicles involved?
A5: No, this specific condition only affects the above vehicles.

Q6: How many incidents of this condition have been reported?
A6: The number of incidents are still under investigation.

Q7: Have there been any accidents reported?
A7: The number of accidents are still under investigation.

Q8: What is Toyota going to do?
A8: Toyota is currently preparing the correction method.

Q9: What should I do if my vehicle is involved in this campaign but so far, have not experienced this condition?
A9: This condition is rare. However, if you have any concerns please contact your nearest Toyota Dealer for assistance.
Q10: I have noticed that my accelerator pedal is hard to depress, slow to return or is unsmooth during operation. What should I do?
A10: Please immediately contact your nearest Toyota Dealer for assistance.

Q11: What if you experience a sticking accelerator pedal while driving?
A11: Each circumstance may vary, and drivers must use their best judgment, but Toyota is providing the following instructions.

• If you need to stop immediately, the vehicle can be controlled by stepping on the brake pedal with both feet using firm and steady pressure. Do not pump the brake pedal as it will deplete the vacuum utilized for the power brake assist.
• Shift the transmission gear selector to the Neutral (N) position and use the brakes to make a controlled stop at the side of the road and turn off the engine.
• If unable to put the vehicle in Neutral, turn the engine OFF. This will not cause loss of steering or braking control, but the power assist to these systems will be lost.
• If the vehicle is equipped with an Engine Start/Stop button, firmly and steadily push the button for at least three seconds to turn off the engine. Do NOT tap the Engine Start/Stop button.
• If the vehicle is equipped with a conventional key-ignition, turn the ignition key to the ACC position to turn off the engine. Do NOT remove the key from the ignition as this will lock the steering wheel.

In the event that a driver experiences an accelerator pedal that sticks in a partial open throttle position or returns slowly to idle position, the vehicle can be controlled with firm and steady application of the brakes.

The brakes should not be pumped repeatedly because it could deplete vacuum assist, requiring stronger brake pedal pressure. The vehicle should be driven to the nearest safe location, the engine shut off and a Toyota dealer contacted for assistance.

Tags: toyota recall answers, toyota recall questions